[MITgcm-support] seaice_salinity
Matthew Mazloff
mmazloff at MIT.EDU
Mon Nov 17 12:30:34 EST 2008
Hello,
OK, so I was only able to make the seaice dynamics stable by turning
down the drags ( I was able to run with SEAICE_WaterDrag = 5 and
SEAICE_drag = 0.001) and turning down the SEAICE_strength (to a value
of 5e-3) and turning down the lsr error to 1e-5.
I am concerned because a very small SEAICE_drag is likely unrealistic
for the SO's largely rough first year ice, and (perhaps more
importantly) because if the winds increase during optimization it may
drive the model back unstable.
I am also disappointed in that running with seaice diagnostics on and
LSR_error = 1e-5 has about doubled the runtime...making using seaice
dynamics not very practical.
So any advice...options. Would coding a simple free drift model be
more stable (and perhaps somewhat realistic). Any ideas?
Thanks a lot,
Matt
On Nov 11, 2008, at 8:13 PM, Dimitris Menemenlis wrote:
> The CS510 solution also has some very saline water in narrow fjords
> around Antarctica. I think what might be happening is that ice is
> acting as a salinity pump, taking freshwater out of the fjord, when
> ice dynamics are turned on, but there is no mechanism for flushing
> the salty water out in the model ocean. Let me know what you
> find. D.
>
> On Nov 11, 2008, at 7:49 PM, Matthew Mazloff wrote:
>
>> Hi Dimitris,
>>
>> The extremes are happening over narrow fjords. But with seaice
>> dynamics off they dont occur. The coldest it gets is -3.14.
>>
>> And yes, I have SEAICE_gamma_t = 259200.
>>
>> Thanks for the help,
>> -Matt
>
> _______________________________________________
> MITgcm-support mailing list
> MITgcm-support at mitgcm.org
> http://mitgcm.org/mailman/listinfo/mitgcm-support
More information about the MITgcm-support
mailing list