[MITgcm-support] Model-output unreadable...

[Alistair Adcroft]

Can you show us the size of the corresponding files?
If you were using
 >> q=rdmds('T',3456);
Then do:
 %   ls -l T.*3456.*

Thx

A.
--
Dr Alistair Adcroft            http://www.mit.edu/~adcroft
MIT Climate Modeling Initiative        tel: (617) 253-5938
EAPS 54-1624,  77 Massachusetts Ave,  Cambridge,  MA,  USA

-----Original Message-----
From: mitgcm-support-bounces at mitgcm.org
[mailto:mitgcm-support-bounces at mitgcm.org] On Behalf Of Uli Riemenschneider
Sent: Friday, August 20, 2004 1:02 PM
To: mitgcm-support at mitgcm.org
Subject: [MITgcm-support] Model-output unreadable...


Hello again,

I have encountered a little problem with the model output files... the 
Matlab routine rdmds.m won't read any of them anymore. I have a feeling 
it might have something to do with the way the output files are formated 
from looking at the Matlab error message and at the program rdmds.m:

??? Error using ==> rdmds (myrdda)
Not enough data was available to be read: off EOF?

Error in ==> /home/ulrike/openbcs/rdmds.m (localrdmds)
On line 292  ==>   A(:,r)=myrdda(dname,ldims,recnum(r),'real*8',ieee);

Error in ==> /home/ulrike/openbcs/rdmds.m
On line 158  ==> [A,N] = localrdmds([Dir allfiles(j).name],ieee,recnum);

The major change I made since the last run (where this was not a 
problem) was that I set the model up with open boundaries in the west 
and south using the OBCS package. Could that have changed the formating 
of the output files????

Thanks
Uli

-- 
*********************************************************
Ulrike Riemenschneider,  Postdoctoral Investigator
Physical Oceanography Dept. MS #21
Woods Hole Oceanographic Institution
Woods Hole, MA 02543, USA

Phone: (+1) 508 289 2916 Fax: (+1) 508 457 2181
*********************************************************

_______________________________________________
MITgcm-support mailing list
MITgcm-support at mitgcm.org
http://dev.mitgcm.org/mailman/listinfo/mitgcm-support