[MITgcm-support] solid boundary with sponge layer

钱钰坤 qianyk at mail3.sysu.edu.cn
Sat Jul 6 09:46:47 EDT 2019


Hi all,


I am using a model setup with a solid north boundary so that no mass exchange
occurs at the north.  This is done using a bathymetry file whose northernmost
grid points are set to zero (e.g., land points).


However, I also need a sponge layer so that the temperature could be restored to
some given profile.  According to the manual, my sponge layer will restore temperature
to the north boundary condition.


Now I'm a little confused.  Since my north boundary is masked by the bathy file, does a
temperature boundary file take some restoring effects in this case?  Or maybe I should
use the rbcs package?




------------------
 Best regards 
 
Yu-Kun Qian (钱钰坤) 
Center for Monsoon and Environment Research 
 Department of Atmospheric Sciences
School of Environmental Science and Engineering 
 Sun Yat-sen University 
No. 135 Xingang West Road, Haizhu District 
Guangzhou, 510275, P.R. China 
Tel; 020-84115227 
Email: qianyk at mail3.sysu.edu.cn
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mailman.mitgcm.org/pipermail/mitgcm-support/attachments/20190706/7ce43e19/attachment.html>


More information about the MITgcm-support mailing list