[MITgcm-support] MITgcm-support Digest, Vol 132, Issue 25

[李志远]

From: Li zhi <oceanlizy at 163.com>
To: MITgcm-support at mitgcm.org
Subject: Re:[MITgcm-support]  how to add tide force at open boundarys

Thank you,Dimitris Menemenlis. 
I think what you told me is very useful for me .And, is there some test cases in mitgcm/verification that use tide force at open boundarys ?
thanks again !


li zhi
on  Jun 26 ,2014,at 07:24 AM, Dimitris Menemenlis <DMenemenlis at gmail.com> wrote:

>An example of adding tides is here:
>http://mitgcm.org/viewvc/MITgcm/MITgcm_contrib/tides/
>
>On Jun 26, 2014, at 7:00 AM, ??? <oceanlizy at 163.com> wrote:
>
>> From: Li zhi <oceanlizy at 163.com>
>> To: MITgcm-support at mitgcm.org
>> Subject: " how to add tide force at open boundarys"
>> My dear mitgcm users,
>>      I run a model with four open boundarys, I specified u ,v,t,s fields at each open boundary, the model run good .Then, I want to add tide force at the four open boundarys . I searched for some useful information in the previous support letters ,but I did not get some . So, can any one  give me some advice ?
>> 
>>  Any quick reply will be greatly appreciated !
>>  Li zhi
>
>
>-------------- next part --------------
>An HTML attachment was scrubbed...
>URL: <http://mitgcm.org/pipermail/mitgcm-support/attachments/20140626/0aec5bc5/attachment-0001.htm>
>
>------------------------------
>
>_______________________________________________
>MITgcm-support mailing list
>MITgcm-support at mitgcm.org
>http://mitgcm.org/mailman/listinfo/mitgcm-support
>
>
>End of MITgcm-support Digest, Vol 132, Issue 25
>***********************************************
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mitgcm.org/pipermail/mitgcm-support/attachments/20140628/6ad7636a/attachment.htm>