Re: 转发： [MITgcm-support] output result problem

[Martin Losch]

Hi Maxiaohui,

please don't send huge file to the list.

You STDOUT.0000 looked OK, but did you check your topography? Is it  
possible that it is zero for the northernmost grid points? What does  
STDOUT.0002 and 0003 look like (please only the beginning, where  
R_low is written to the sceen)?

Martin

On 14 Oct 2008, at 05:28, Maxiaohui wrote:

>
>
> 注：已附加转发邮件。
>
> 雅虎邮箱，您的终生邮箱！
>
> From: Maxiaohui <maxiaohui823 at yahoo.cn>
> Date: 13 October 2008 13:45:42 GMT+02:00
> To: mitgcm <mitgcm-support at mitgcm.org>
> Subject: [MITgcm-support] output result problem
> Reply-To: mitgcm-support at mitgcm.org
>
>
> Hi,all,
>
> I'm doing an experiment with open boundary, now  I meet a  
> problem.It only gives partial results,the result of my south area  
> is all right ,but the northern part (about 40 grids) turns out to  
> be all zero(land point),and this happens with all the output datas 
> (t,s,u,v,etc.) .My input files are right,the northern area does  
> have datas(with zeroland points and nonzero wet points).
>  So what may cause this problem ? Could anyone  tell me what may be  
> wrong with my experiment?
> Thank you very much!
> Enclosed is my STDOUT file.
>
> Xiaohui
>
> 雅虎邮箱，您的终生邮箱！<STDOUT.0000>
> _______________________________________________
> MITgcm-support mailing list
> MITgcm-support at mitgcm.org
> http://mitgcm.org/mailman/listinfo/mitgcm-support
>
>
> _______________________________________________
> MITgcm-support mailing list
> MITgcm-support at mitgcm.org
> http://mitgcm.org/mailman/listinfo/mitgcm-support