[MITgcm-support] rbcs and adjoint

Patrick Heimbach heimbach at MIT.EDU
Mon Jul 10 14:01:13 EDT 2006


Hi Lars,

that sounds like an extensive recomputation problem,
likely a part of the rbcs state isn't properly
stored for lev3 and lev2,
a guess in the absence of availability of your config
(would need to look into taf_ad.log).

Best way to test and fix is if you could send me
a self-consistent code/ dir. with usual
header files, and I'll look into it.

-Patrick



On Mon, 2006-07-10 at 13:35, Lars Czeschel wrote:
> Hi all,
> 
> Does anybody use the rbcs package in the adjoint model?
> If I use rbcs the model writes out tapelevel3 as normal,
> but afterwards the model seems to be trapped in an 
> infinite loop, i.e. the whole forward run is repeated again
> and again without writing out tapelevel2.
> The same setup works fine without rbcs.
> 
> Thanks for your help,
> Lars
> 
> --------------------------
> Lars Czeschel
> Department of Meteorology
> University of Reading
> PO Box 243
> Reading RG6 6BB
> Phone: +44 (0)118 378 7997
> 
> 
> _______________________________________________
> MITgcm-support mailing list
> MITgcm-support at mitgcm.org
> http://mitgcm.org/mailman/listinfo/mitgcm-support
-- 
--------------------------------------------------------
Patrick Heimbach   Massachusetts Institute of Technology
FON: +1/617/253-5259                  EAPS, Room 54-1518
FAX: +1/617/253-4464             77 Massachusetts Avenue
mailto:heimbach at mit.edu               Cambridge MA 02139
http://www.mit.edu/~heimbach/                        USA




More information about the MITgcm-support mailing list