[MITgcm-support] input file for &PARM01!

[Stefano Querin]

Hi,
you just have to specify

hydrogThetaFile='ini_temp',

in  &PARM05  (ini_temp should contain a 3D initial T field).
I think the model should 'overwrite' the values specified in   tRef 
(anyway, simply comment tRef out...).
That should be enough!
Bye,

Stefano


----- Original Message ----- 
From: "Van Thinh Nguyen" <vtnguyen at moisie.math.uwaterloo.ca>
To: "MITgcm Support" <mitgcm-support at mitgcm.org>
Sent: Monday, May 02, 2005 6:00 PM
Subject: [MITgcm-support] input file for &PARM01!


>
> Hi,
>
> Is it possible to input a file on the line as follows:
>
>  tRef='ini_temp'
>
> The "ini_temp' is obtained from Matlab, which has done almost the same way
> to get the wind force file "windx.sin_y' in the example exp0. Because I 
> would
> like to set up an initial condition for Temperature (like a slope of
> thermocline between upper & lower layers of water depth).
>
> Please give an advice, if some one would know about this.
>
> Thanks
>
> Van Thinh
> _______________________________________________
> MITgcm-support mailing list
> MITgcm-support at mitgcm.org
> http://mitgcm.org/mailman/listinfo/mitgcm-support
>