[MITgcm-devel] balance fluxes in exf

[Martin Losch]

Hi,
thanks for the replies. I have now implemented a routine that can  
substract the mean of either EmPmR or/and Qnet in exf_getforcing.F.  
However, while this balances the fluxes, the mean sea surface height  
is still drifting.

I suspect (but haven't look into it yet), that the seaice-model  
changes empmr to cause this drift. What I should probably do is to  
call this balancing routine after or at the end of  
do_oceanic_physics.F to make sure that the fluxes are balanced. Then  
it would no longer be part of the exf-package.

What do you think about this? Is there a need for this.

Martin


On Feb 8, 2006, at 11:03 PM, Patrick Heimbach wrote:

>
> Hi Martin,
> there is no such switch.
> -Patrick
>
>
>
> On Mon, 2006-02-06 at 16:26, Dimitris Menemenlis wrote:
>> Martin, I am not aware of such a switch:
>>
>>> is there a switch to balance the fluxes computed by  
>>> exf_bulkformulae.F
>>
>> Dimitris
>> _______________________________________________
>> MITgcm-devel mailing list
>> MITgcm-devel at mitgcm.org
>> http://mitgcm.org/mailman/listinfo/mitgcm-devel
> -- 
> --------------------------------------------------------
> Patrick Heimbach   Massachusetts Institute of Technology
> FON: +1/617/253-5259                  EAPS, Room 54-1518
> FAX: +1/617/253-4464             77 Massachusetts Avenue
> mailto:heimbach at mit.edu               Cambridge MA 02139
> http://www.mit.edu/~heimbach/                        USA
>
> _______________________________________________
> MITgcm-devel mailing list
> MITgcm-devel at mitgcm.org
> http://mitgcm.org/mailman/listinfo/mitgcm-devel